AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Aku shaper operation manual12/16/2023 ![]() ![]() For more information on nose rockers, please visit here: Rockers - A beginners guide to board building The rocker is measured from the bottom plane of your design to the bottom tip of the board. Nose Rocker: Nose rocker dimensions are displayed here. Thickness can be increase at any point on your design, we list the 1' measurements for reference. Thickness adjustments can also be made in the top/bottom tabs. Thickness 1' from the nose and tail are displayed. Thickness: Thickness measurements are displayed here. To increase/decrease the width at the nose and tail, use the control points. Width: Width measurements are displayed for center, 1' from the nose, and 1' from the tail of your design. Select Straight line or Over the Curve.Īuto Adjust: Auto adjusting slices and rocker/thickness is used to scale an existing shape without the need to reshape the rails or change the rocker due to a change in the dimensions Input your desired dimensions using a decimal or fraction. Length/Pencil Key: Use this key to change the dimensions of your design We provide both options based on your previous shaping style. Over the Curve: Over the curve measurements account for the increased length due to the curve of the rocker.ĭetermining whether to use straight line versus over the curve is a shaper preference. Straight Line: Straight line measurements are taken from tip to tip of a surfboard, not accounting for increased length due to the rocker of a blank or design How to: Change dimensions Startup Guide on how to use the AkuShaper Dimensions Panel Straight Line versus Over the Curve ![]()
0 Comments
Read More
Leave a Reply. |